5 Car, Bike or Kart between $30,000 & $50,000 for sale
Most Recent
Most Recent
Keyword
Price
Listing Type
All Results
8
Roll CageLog Book
S3 RX7 Rally car, fresh rebuild with only two events since completion. (2022 Alpine, 2023 Southern Cassic) 13B Bridge port with 48IDA, approx 250hp ATWs, stainless extractors, remote oil filter, new PWR oil coiler with new oil lines RX8 close ratio gearbox S3 4.89 LSD with strengthened housing MCA with remote canisters, two events old S4 steering, struts and 4 pot calipers All new wiring loom Twin carter fuel pumps Braided fuel and brakes through out Pedal box with Willwood cylinders Hydraulic h
6
Roll CageLog Book
This Mallock U2 was built under license in New Zealand in 1969 using all the usual components. It raced successfully for 10 years when it was purchased by a prominent racer/constructor as a base for a sports racing car to compete in the SCANZ national sports car championship during the 1980's. It was a very competitive car winning 5 championships and holding lap records at every circuit. The car was then retired and stayed with the owner/driver until the late 90's when a comprehensive restoratio
5
Registered
1979 fully restored rx7 series 1. Has hade full respray including jambs and engine bay. Restoration of interior. Original roof lining and door skins. Fully rebuilt factory 12a only done 500kms. Original wheels. Fantastic car.
26
RegisteredRoll CageLog Book
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute