7 Motorsport Vehicles for sale
Most Recent
Most Recent
Keyword
Category
Price
Listing Type
All Results
6
Completely rebuilt over the last period of Covid, ground up restoration, has not been on a track since rebuild. Fitted with a Nissan FJ 20 ET engine with forged internals and Motec management. Will need testing and sorting, just been dynoed at low boost to give the engine a bit of run time, comes with mounted wets and spare new fronts, a complete new forged engine in dismantled form, 3 engine blocks and 4 cylinder heads, and a mass of spares including 2 gearboxes. Was originally raced bu Keith L
8
Roll CageLog Book
S3 RX7 Rally car, fresh rebuild with only two events since completion. (2022 Alpine, 2023 Southern Cassic) 13B Bridge port with 48IDA, approx 250hp ATWs, stainless extractors, remote oil filter, new PWR oil coiler with new oil lines RX8 close ratio gearbox S3 4.89 LSD with strengthened housing MCA with remote canisters, two events old S4 steering, struts and 4 pot calipers All new wiring loom Twin carter fuel pumps Braided fuel and brakes through out Pedal box with Willwood cylinders Hydraulic h
14
Roll Cage
Chevrolet camaro 1968 drag car tabbed 15 inch wide wheels Dana diff front fiberglass clip imported from states. . Cage so much work in car left hand drive set up for big block Chevrolet twin turbo also have pipes made for twin gt42s
40
Roll Cage
2021 Chevrolet Camaro Gen 3 #001 Prototype V8 Supercar CHASSIS: #SC-001 / 888A-056 BUILT: 2021 ENGINE: 5.7-litre V8 pushrod by KRE MANUFACTURER: Triple Eight Race Engineering The Gen3 Chevrolet Camaro prototype was the first Gen3 Supercars chassis assembled and undertook a rigorous testing programme ahead of the platform’s induction to the 2023 Repco Supercars Championship. Owned by Supercars, the car was built by 11-time Supercars teams’ champions and Chevrolet Homologation Team, Triple Eigh
4
Roll CageLog Book
Competed in the 2023 National Trans Am Championship and finished inside the top 10. Professionally maintained by Dream Racing Australia between each event. New front and rear brakes (Pads & Rotors) Motec Tps sensor upgrade, Soild plate clutch upgrade, Larger oil cooler upgrade, Air box upgrade, Tail shaft with upgraded yoke and new uni-joints, Rebuilt diff, Recently serviced gearbox, Spare Front Bar, Spare Sway bar, 8 Rims (4 x slicks & 4 x wets) Leak down test performed after last round
4
This immaculate C6 corvette is race ready with no expense spared. Some features include the following: Coil over suspension QA1 suspension Front splitter Rear carbon fiber wing Upgraded brakes 6 piston front and 4 piston in the rear Auto blip computer Quick release steering wheel Roll Cage Fuel Cell Haltech dash with new wiring approx $10,000 Light weight racing battery Isolators Polycarbonate front windscreen Polycarbonate rear windscreen Car has been completely guttered only weighs 1,200 ki
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute